Article ID: 304514 - Last Review: October 18, 2001 - Revision: 1.1
How to Configure Device Manager to Display Detailed Information
This article was previously published under Q304514
SUMMARY
If you require additional device information that is not typically displayed in Device Manager, you can configure Device Manager to show detailed information.
MORE INFORMATION
To configure Device Manager to show details:
For additional information about related topics, click the article numbers below to view the articles in the Microsoft Knowledge Base:
- Click Start, click Run, type cmd.exe, and then press ENTER.
- Type set DEVMGR_SHOW_DETAILS=1, and then press ENTER.
- Type start devmgmt.msc, and then press ENTER. In Device Manager the properties for a device should now provide a Details tab that contains additional information about the device.
- Device Instance ID
- Hardware IDs
- Compatible IDs
- Matching Device ID
- Service
- Enumerator
- Capabilities
- Devnode Flags
- Config Flags
- CSConfig Flags
- Ejection Relations
- Removal Relations
- Bus Relations
- Device Upper Filters
- Device Lower Filters
- Class Upper Filters
- Class Lower Filters
- Class Installer
- Class Coinstallers
- Device Coinstallers
- Firmware Revision
- Current Power State
- Power Capabilities
- Power State Mappings
For additional information about related topics, click the article numbers below to view the articles in the Microsoft Knowledge Base:
283658
(http://support.microsoft.com/kb/283658/EN-US/
)
How to Manage Devices in Windows XP
244601
(http://support.microsoft.com/kb/244601/EN-US/
)
How to Troubleshoot Unknown Devices Listed in Device Manager
125174
(http://support.microsoft.com/kb/125174/EN-US/
)
Explanation of Error Codes Generated by Device Manager
133240
(http://support.microsoft.com/kb/133240/EN-US/
)
Troubleshooting Device Conflicts with Device Manager
Note: This article is from Microsoft Knowledage Base
Related problems posted by other users | |
| more... |

